AEG Dryer tE Error Code: Causes and Fixes
Quick answer: Temperature reading fault
What you’ll notice
Temperature reading is absent or locked at an extreme value from the start of the cycle.
AEG
Dryer
Code tE
high severity
AEG models: AEG heat-pump dryers have two lint filters: the primary in the door opening and a secondary condenser filter in the lower plinth (pull the plinth cover down to access). Clean the secondary filter every 5 cycles. Vented AEG dryers have only the door-opening filter.
Common causes
- Thermistor completely failed before the cycle runs
- Wiring to the thermistor open
Step-by-step fix
- Same as E1 — test thermistor at room temperature before any cycle.
Tools you may need
MultimeterScrewdriver set
Prevention
- Inspect thermistor leads annually for brittleness caused by heat exposure.
When to stop DIY
Replace the thermistor; do not run the dryer without a working temperature sensor.
FAQ
What does tE mean on AEG dryer?
tE usually indicates: Temperature reading fault.
Can I keep using the appliance with tE?
Use caution. Severity is high. Replace the thermistor; do not run the dryer without a working temperature sensor.
How long does this fix usually take?
Typical first-pass troubleshooting takes 30–45 minutes.