AEG Dryer E2 Error Code: Causes and Fixes
Quick answer: Thermistor short/open
What you’ll notice
Temperature reading stays at maximum, minimum, or is erratic during the cycle.
AEG
Dryer
Code E2
high severity
AEG models: AEG heat-pump dryers have two lint filters: the primary in the door opening and a secondary condenser filter in the lower plinth (pull the plinth cover down to access). Clean the secondary filter every 5 cycles. Vented AEG dryers have only the door-opening filter.
Common causes
- Thermistor short circuit
- Wiring harness to thermistor damaged
Step-by-step fix
- Same diagnostic steps as E1 but focus on short circuit — look for a very low resistance value (close to 0) rather than open.
- Inspect wiring for any pinched or burnt insulation.
Tools you may need
MultimeterScrewdriver set
Prevention
- Route replacement thermistor wiring away from heat sources.
When to stop DIY
Replace the thermistor; if wiring is damaged, a technician should repair the harness.
FAQ
What does E2 mean on AEG dryer?
E2 usually indicates: Thermistor short/open.
Can I keep using the appliance with E2?
Use caution. Severity is high. Replace the thermistor; if wiring is damaged, a technician should repair the harness.
How long does this fix usually take?
Typical first-pass troubleshooting takes 30–45 minutes.