AEG Dryer PF Error Code: Causes and Fixes
Quick answer: Power interruption detected
What you’ll notice
Dryer stopped mid-cycle; control board detected a power interruption.
AEG
Dryer
Code PF
high severity
AEG models: AEG heat-pump dryers have two lint filters: the primary in the door opening and a secondary condenser filter in the lower plinth (pull the plinth cover down to access). Clean the secondary filter every 5 cycles. Vented AEG dryers have only the door-opening filter.
Common causes
- Utility power cut
- Tripped circuit breaker (electric dryers need a double-pole breaker)
- Loose connection at the outlet or terminal block
Step-by-step fix
- Check the circuit breaker — reset if tripped.
- For a 240V electric dryer, the breaker has two handles; if only one tripped, reset both.
- Resume the interrupted cycle.
- If breakers trip repeatedly, have an electrician inspect the outlet and wiring.
Tools you may need
None
Prevention
- Have the dryer outlet and wiring inspected every few years.
- Do not run the dryer on an extension cord.
When to stop DIY
Call an electrician if the breaker trips again during the same cycle.
FAQ
What does PF mean on AEG dryer?
PF usually indicates: Power interruption detected.
Can I keep using the appliance with PF?
Use caution. Severity is high. Call an electrician if the breaker trips again during the same cycle.
How long does this fix usually take?
Typical first-pass troubleshooting takes 2 minutes.