AEG Dryer D90 Error Code: Causes and Fixes
Quick answer: Severe vent blockage
What you’ll notice
Dryer shuts off early or runs very hot; airflow sensor detects near-complete blockage.
AEG
Dryer
Code D90
medium severity
AEG models: AEG heat-pump dryers have two lint filters: the primary in the door opening and a secondary condenser filter in the lower plinth (pull the plinth cover down to access). Clean the secondary filter every 5 cycles. Vented AEG dryers have only the door-opening filter.
Common causes
- Severe lint buildup in the duct — same root cause as D80 but more advanced
- Exterior vent cap flap stuck closed
Step-by-step fix
- Treat as D80 but with urgency — a D90 is a fire risk if unaddressed.
- Disconnect and fully clean the duct before running the dryer again.
- Verify the exterior flap opens freely during operation.
Tools you may need
Vacuum with narrow attachmentDryer vent brush kit
Prevention
- Same as D80. A D90 after a D80 was ignored is a warning sign.
When to stop DIY
Do not continue using the dryer while the D90 is active. If you find scorching on the duct or lint trap housing, have it professionally inspected.
FAQ
What does D90 mean on AEG dryer?
D90 usually indicates: Severe vent blockage.
Can I keep using the appliance with D90?
Use caution. Severity is medium. Do not continue using the dryer while the D90 is active. If you find scorching on the duct or lint trap housing, have it professionally inspected.
How long does this fix usually take?
Typical first-pass troubleshooting takes 20–40 minutes.