Miele Dryer E2 Error Code: Causes and Fixes
Quick answer: Thermistor short/open
What you’ll notice
Temperature reading stays at maximum, minimum, or is erratic during the cycle.
Miele
Dryer
Code E2
medium severity
Miele models: Miele heat-pump and condenser dryers do not vent externally; condensate drains to a collection tank or a direct-drain connection. The door-opening lint filter is the primary filter, but there is a secondary condenser fluff filter in the lower plinth that must be cleaned monthly. A full condensate tank will pause the cycle without an explicit error.
Common causes
- Thermistor short circuit
- Wiring harness to thermistor damaged
Step-by-step fix
- Same diagnostic steps as E1 but focus on short circuit — look for a very low resistance value (close to 0) rather than open.
- Inspect wiring for any pinched or burnt insulation.
Tools you may need
MultimeterScrewdriver set
Prevention
- Route replacement thermistor wiring away from heat sources.
When to stop DIY
Replace the thermistor; if wiring is damaged, a technician should repair the harness.
FAQ
What does E2 mean on Miele dryer?
E2 usually indicates: Thermistor short/open.
Can I keep using the appliance with E2?
Use caution. Severity is medium. Replace the thermistor; if wiring is damaged, a technician should repair the harness.
How long does this fix usually take?
Typical first-pass troubleshooting takes 30–45 minutes.