Maytag Dryer H1 Error Code: Causes and Fixes
Quick answer: Overheat protection event
What you’ll notice
Dryer shuts off; overheat protection has activated.
Maytag
Dryer
Code H1
high severity
Maytag models: Same platform as Whirlpool. Lint filter in door opening; thermal fuse on the exhaust duct inside the back panel. Maytag Bravos MCT models use a direct-drive motor with no belt — a belt-break diagnosis does not apply to these units.
Common causes
- Restricted exhaust airflow causing heat buildup
- Cycling thermostat failed in the closed position
- High-limit thermostat holding open
Step-by-step fix
- Clear the vent duct completely (see D80 steps).
- Test the cycling thermostat — it should open and close as temperature changes.
- If the dryer overheats even with a clear duct, the cycling thermostat has failed and needs replacement.
Tools you may need
MultimeterScrewdriver set
Prevention
- Clean the vent duct annually.
- Replace the cycling thermostat if the dryer regularly runs very hot.
When to stop DIY
If any component shows signs of heat damage or scorching, call a technician before running the dryer again.
FAQ
What does H1 mean on Maytag dryer?
H1 usually indicates: Overheat protection event.
Can I keep using the appliance with H1?
Use caution. Severity is high. If any component shows signs of heat damage or scorching, call a technician before running the dryer again.
How long does this fix usually take?
Typical first-pass troubleshooting takes 30–60 minutes.