GE Oven F5 Error Code: Causes and Fixes
Quick answer: Control board communication issue
What you’ll notice
Oven stops and shows F5; a communication fault between control boards has been detected.
GE
Oven
Code F5
low severity
GE models: The RTD temperature probe on GE ovens mounts at the back wall of the cavity and unscrews from inside — no rear panel removal needed. Diagnostic mode on most GE ranges: hold Bake + Broil Hi simultaneously for 5 seconds. The tech sheet is inside the frame behind the storage drawer.
Common causes
- Main control board to display/relay board communication interrupted
- Power surge corrupted communication state
- Ribbon cable or connector loose
Step-by-step fix
- Power cycle (breaker off for 5 minutes).
- If recurring, open the control panel and reseat the ribbon cable between boards.
- Inspect for burn marks.
Tools you may need
Screwdriver set
Prevention
- Use a surge protector on the oven circuit.
When to stop DIY
Call a technician for control board replacement if the fault persists.
FAQ
What does F5 mean on GE oven?
F5 usually indicates: Control board communication issue.
Can I keep using the appliance with F5?
Use caution. Severity is low. Call a technician for control board replacement if the fault persists.
How long does this fix usually take?
Typical first-pass troubleshooting takes 5 minutes (reset); 30 minutes (cable check).