AEG Washer F9 Error Code: Causes and Fixes
Quick answer: Drain performance low
What you’ll notice
Drain cycle exceeds expected duration; machine judges drain performance inadequate.
AEG
Washer
Code F9
low severity
AEG models: AEG is owned by Electrolux and shares the same platform. The pump filter is behind the lower-right service panel. AEG's ÖKOMix technology pre-mixes detergent with water before the main cycle — the brief agitation before fill begins is a designed pre-wash, not a fault.
Common causes
- Partially blocked pump filter reducing flow
- Drain hose routed too high, increasing back-pressure
- Pump impeller starting to wear
Step-by-step fix
- Clean the pump filter (see OE steps above).
- Ensure the drain hose peak is no higher than 100 cm from the floor.
- Run a drain-only cycle and listen for the pump — a healthy pump sounds steady, a worn one may pulse or whine.
Tools you may need
Shallow traySmall brush
Prevention
- Clean the filter monthly.
- Do not route the drain hose higher than specified in the installation manual.
When to stop DIY
If drain performance is slow even after clearing the filter, the pump is wearing and should be replaced before it fails completely.
FAQ
What does F9 mean on AEG washer?
F9 usually indicates: Drain performance low.
Can I keep using the appliance with F9?
Use caution. Severity is low. If drain performance is slow even after clearing the filter, the pump is wearing and should be replaced before it fails completely.
How long does this fix usually take?
Typical first-pass troubleshooting takes 10–20 minutes.